Plans have material lists, with screw quantities for Cap & Trim. - - Back to Install Details
----
 
Basics:
 
Place one screw every 12" along Cap & Corner face (Cap requires 9 screws, Corner 18).
.
Also place screws every 12" along perimeter of roof & walls, Details show screw placement.
 
Screws also used at mid-sheet. -

Roof -
-• Use 1 screw per foot along the top edge of roof slope. Set screw through ridge flashing and into blocking below.
-• Use 1 screw per foot along the lower edge of sheet, position between Cap.
-• Aluminum Corner Trim (use 1 screw 2" from ends and every 12" along each leg of Corner).
Walls-
-• Aluminum Corner Trim (use 1 screw 2" from ends and every 12" along each leg of Corner).
-• On side or front walls, use 1 screw per foot along the top & bottom edge of sheet, position between Cap. Screw goes through sheet and into blocking or top & bottom plates.
-• On gable ends, with Corner Trim at top of sheet, place 1 screw per foot along the bottom edge of sheet, position between Cap. Screw goes through sheet and into blocking or bottom plates. See above for screw placement in Corner Trim.
 
Around Doors, Fans, Shutters 1 screw every 12" around perimeter of these items as needed.
 
Specify wood, pressure treated wood, steel or aluminum frame when ordering. Screws to hold on U-Profile also provided.
 
 
 
-  
-